Coax to every TV is a 2005 habit. Here's how we wire for the way you watch now.
Look behind the TVs in almost any Central Oregon home built in the last twenty years and you'll find the same thing: a coax jack in every bedroom, the den, the bonus room, sometimes the garage. Most of them haven't carried a signal in years.
That wiring made sense when it went in. Every TV needed a cable box, every cable box needed a coax line, and the whole house hung off a splitter in the garage. Builders ran coax to every room because that's what TV was.
People don't watch that way anymore. In Nielsen's August 2026 report, streaming made up 49.6% of all TV viewing in the U.S. Cable was 18.9%. Netflix, YouTube, and the streaming versions of the channels you already watch all reach the TV over your home network, not a coax line.
So if you're building or remodeling, the question has changed. Forget "where do the cable jacks go?" The better question is how does each TV get a solid network connection, and how do we keep that wall flexible for whatever comes next?

What actually reaches your TV now
A modern TV is a networked device. The apps are built in or plugged in on a streaming stick, and everything it plays arrives over the internet.
That changes what the wall needs. A 4K stream isn't huge; Netflix recommends 15 Mbps for Ultra HD. The real issue is consistency. A TV at the far end of the house, behind a stone fireplace, sharing Wi-Fi with every phone, camera and laptop in the home, is where you get the spinning wheel in the fourth quarter.
A wired TV doesn't have that problem. It also takes one of the busiest devices in the house off your Wi-Fi, which leaves more room for the phones and laptops that actually move around. We covered the bigger network picture in our builder's guide to new-construction Wi-Fi.
What we run to a TV location today
This is our standard on new construction and gut remodels. It's built for the TV you hang this year and the one that eventually replaces it.
Primary TVs (great room, family room, media room):
A recessed power and data box behind the TV, inside the mount's footprint, so nothing hangs below the screen.
Two Cat6 cables back to the equipment closet. One for the TV, one spare for a streaming box, a game console, or whatever shows up next.
An empty 1¼-inch conduit with a pull string, running to the equipment closet or a nearby cabinet. This is the one people skip and regret.
Blocking sized for the mount that's actually going on the wall.
Secondary TVs (bedrooms, office, gym):
Power and a recessed box at mount height.
At least one Cat6, ideally two.
Patio and outdoor TVs:
Cat6, weather-rated power, and conduit. Wi-Fi fades fast outside the walls, and patio TVs almost always sit at the edge of coverage. Our outdoor living guide covers the rest of the backyard.
Notice what's missing from every list: coax.
Why the conduit matters more than the cable
Cables age. Connector standards change every few years. An empty conduit doesn't care.
That pipe is what lets us pull a new cable when a new standard arrives without opening the wall. It's how we run an HDMI or fiber connection from a hidden cabinet when you want the equipment out of sight. And it's how art-style TVs get installed cleanly. Samsung's The Frame, for example, connects to a separate One Connect box through a single thin cable. A 5-meter cable comes in the box and a 15-meter version is sold separately, so with the right conduit the box lives in a nearby cabinet instead of on a shelf under the screen.
We've written more about hidden TVs and concealed speakers if that's the look you're after.
Want the equipment out of the room entirely?
Some clients want nothing under the TV at all. No streaming box, no receiver, no blinking lights. That's very doable.
The equipment lives in the closet, and the picture gets sent to the TV over network cable using HDBaseT, an industry standard for carrying uncompressed HDMI video over a single category cable. With the right equipment it carries 4K up to about 330 feet, with Cat6A for the longest runs. One remote, one clean wall, and the gear gets serviced in the closet instead of behind a mounted TV.
It isn't for every room. For the great room or a media room, it's often the right call. For a guest bedroom, a TV with good built-in apps on a wired connection does the job.
Where coax still belongs
We're not anti-coax. It still has real jobs. Just not in every room.
The service line. If your internet comes in over cable, that coax lands in the equipment closet and stops there.
Satellite. Some properties still use it. If yours will, plan the dish location and its cable route like any other exterior device.
Out here, plenty of homes skip the cable company entirely and run on fiber or Starlink. Starlink uses its own cable, not coax, so that's a separate route to plan before the siding goes on.
What's different about a Central Oregon home
Second homes. A house in Sunriver, Black Butte Ranch or Sisters that sits empty half the year doesn't need a cable box in every room. Streaming apps on wired TVs are simpler for owners and guests alike, and there's less equipment to troubleshoot from three states away.
Long single-level plans. A great room at one end of the house and the equipment closet at the other adds up distance quickly. That's one more reason to settle the closet location early.
Stone walls. A stacked-stone fireplace wall is beautiful, and it doesn't come apart. Whatever goes behind a TV mounted on stone has to be in before the mason starts. Box, two Cat6, conduit. Done.
Where we'd tell you to skip it
We're not in the business of selling wire nobody needs.
Don't run coax to every room "just in case." Ethernet and an empty conduit cover "just in case" far better.
Don't run HDBaseT to every bedroom. A wired TV with built-in apps is plenty for most secondary rooms.
Don't buy the TVs at framing. Buy the wiring now and the TVs closer to move-in. Models change fast.
Don't bury an HDMI cable in the wall with no way to replace it. That's exactly what the conduit is for.
The TV wiring checklist
Before the walls close, confirm:
Every TV location is on the plans, at a height set from the furniture plan.
Each primary TV has a recessed box, two Cat6, a 1¼-inch conduit and blocking.
Each secondary TV has power and at least one Cat6.
Patio TVs have Cat6, weather-rated power and conduit.
Coax is limited to the service entry, and satellite if you need it.
The equipment closet is set, in conditioned space, with room for what's coming.
Every cable is labeled and photographed before insulation.
The TV you buy this year will get replaced. The wiring behind it won't. Wire for that.
Building or remodeling in Central Oregon? Send us your plans before rough-in and we'll mark up every TV location: what to run, where it goes, and what you can skip. Start a conversation, call us at (541) 241-8114, or come see a clean TV wall in person at our Technology Design Center in Bend.
Designers and builders: here's the full trade-by-trade list of what to prewire before drywall, and how we work with design and build partners.
SecuraCore: Technology made simple. More Central Oregon smart home advice on our blog.
Viewing figures are from Nielsen's The Gauge, August 2026. Streaming bandwidth is Netflix's published recommendation. HDBaseT distances vary by equipment and cable. This is general planning guidance; final wiring depends on the home, the equipment selected and your building official.




Comments